Schedule your air conditioner tune-up with Air Systems Mechanical in Wexford, PA
For air conditioning repair in Beaver Falls, PA like us on Facebook! For AC repair in Beaver Falls PA visit us on Google. Read what your neighbors say about the air conditioning repair or installation we performed new New Brighton, PA on our Angie's List page. For furnace repair tips in New Brighton, PA read our blog.
 
PA License #: PA003439
(724) 774-9030 / (412) 264-3201
Exceeding Your Expectations Through Results
Heating System Replacement Tips

Heating System Efficiency & Replacement Tips

Space heating is the largest energy expense in most homes, accounting for two-thirds of annual energy bills in cold climates.

Why Buy an Energy Efficient Furnace/Boiler?

Heating is the largest energy expense in most homes, accounting for almost two-thirds of annual energy bills in colder areas of the country. Heating systems in the United States emit a billion tons of carbon dioxide (CO2) and about 12% of the sulfur dioxide and nitrogen oxides emitted by the nation. Reducing energy use for heating is the single most effective way to reduce your home's contribution to global environmental problems.

Conservation efforts and a new high-efficiency heating system can often cut your pollution output and fuel bills in half. Upgrading your furnace or boiler from an AFUE (annual fuel utilization efficiency) of 56% to 90% in an average cold-climate house will save 1.5 tons of CO2 emissions if you heat with gas or 2.5 tons if you heat with oil and will cut your heating bill by almost 40%.

If your furnace or boiler is old, worn out, inefficient, or significantly oversized, the simplest solution is to replace it with a modern high-efficiency model. Old coal burners that were switched over to oil or gas are prime candidates for replacement, as well as gas furnaces without electronic (pilotless) ignition.

About Furnace/Boiler Efficiency

A central furnace or boiler's efficiency is measured by annual fuel utilization efficiency (AFUE). AFUE is a measure of how efficient the appliance is in using fossil fuel (gas or oil) or electricity (for an electric furnace) over a typical year of use.

An all-electric furnace or boiler has no flue loss through a chimney. The AFUE rating for an all-electric furnace or boiler is between 95% and 100%. The lower values are for units installed outdoors because they have greater jacket heat loss.

The efficiency of manufactured furnaces is governed by the National Appliance Energy Conservation Act of 1987 and regulated by the U.S. Department of Energy. The minimum allowed AFUE rating for a noncondensing, fossil-fueled, warm-air furnace is 78%; the rating for a fossil-fueled boiler is 80%; and the rating for a gas-fueled steam boiler is 75%. A condensing furnace or boiler condenses the water vapor produced in the combustion process and captures the heat released from this condensation. The AFUE rating for a condensing unit can be much higher (by more than 10 percentage points) than a noncondensing furnace. Although a condensing unit costs more than a noncondensing unit, the condensing unit can save you money in fuel costs over the 15 to 20-year life of the unit.

Tips for Buying a New Furnace/Boiler

  • If you live in a cold climate, it usually makes sense to invest in the highest efficiency system available. In milder climates with lower annual heating costs, the extra investment required to go from 80% to 90%-95% efficiency may be hard to justify.
  • When shopping for high-efficiency furnaces and boilers, look for dependability. Buy a system with a good warranty and a reputable company to back it up.
  • When buying gas and oil systems, specify sealed combustion. Sealed-combustion appliances bring outside air directly into the burner and exhaust flue gases (combustion products) directly to the outside, without the need for a draft hood or damper. They generally burn more efficiently and pose no risk of introducing dangerous combustion gases into your house. With nonsealed-combustion appliances, back-drafting of combustion gases can be a big problem, especially in tightly-sealed modern homes.

Tips for Lowering Your Furnace/Boiler's Energy Usage

  • Set your thermostat as low as is comfortable.
  • Keep the temperature fairly constant, as frequent changes will utilize more energy by causing unnecessary cycling on and off. Setting back the temperature at night, however, is recommended.
  • Clean or replace furnace filters once a month or as needed.
  • Oil-fired boilers should be professionally cleaned and tuned once a year. Gas-fired equipment needs to be checked every other year.
  • Clean warm-air registers, baseboard heaters, and radiators as needed; make sure they are not blocked by furniture, carpeting, or drapes.
  • Keep draperies and shades on south-facing windows open during the heating season to allow sunlight to enter your home; close them at night to reduce the chill you may feel from cold windows.
  • Close the door to an unoccupied room or area that is isolated from the rest of the house and turn down the thermostat or turn off the heat for that room or area.
  • Use kitchen, bath, and other ventilating fans wisely. Turn these fans off as soon as they are no longer needed. In about 1 hour, these fans can pull out a house-full of warmed or cooled air. They can also pull dangerous furnace combustion gasses into the house in some situations.
  • Check your ducts for air leaks. First look for sections that should be joined but have separated and then look for obvious holes.
  • Do not use duct tape to repair leaky ducts. Standard duct tape has been shown unreliable in sealing duct leaks. Various mastics or non-cloth-backed tapes are preferable.

Source: U. S. Department of Energy



Let Air Systems Mechanical give you an indoor air quality evaluation in Prospect, PA
Air Systems Mechanical Contracting, Inc.

427 Constitution Blvd.
New Brighton, PA 15066
(724) 774-9030
Business Hours:
Monday - Friday:
8:00am - 4:00pm
24 Hour / 7 Days
Emergency Service
Air Systems Mechanical Contracting, Inc. works with American Standard AC products in Beaver Falls PA.
Air Systems Mechanical is a member of IGSHPA
For your AC repair in New Brighton PA, trust a NATE certified contractor.
Air Systems Mechanical is a participating contractor in First Energy energy efficiency program.

 
Air Systems Mechanical Contracting, Inc. is a Pennsylvania (PA) Heating, Cooling, Plumbing, Air Conditioning, Geothermal, Furnace Repair, service, replacement, duct cleaning and maintenance Contractor located in Beaver County, PA.  Air Systems will send you their best technician for your boiler repairs, furnace repairs, a/c repairs, propane furnace repairs, furnace replacements, a/c replacements, boiler replacements in Aliquippa PA, Ambridge PA, Baden PA, Beaver PA, Beaver Falls PA, Bradfordwoods PA, Clinton PA, Conway PA, Coraopolis PA, Cranberry PA, Darlington PA, Ellwood City PA, Enon Valley PA, Evans City PA, Fombell PA, Freedom PA, Georgetown PA, Harmony PA, Hookstown PA, Imperial PA, Industry PA, Midland PA, Monaca PA, New Brighton PA, Rochester PA, Sewickley PA, Zelienople PA, Leetsdale PA, Montour PA, New Galilee PA, Prospect PA, Wampum PA,Warrendale PA, and Wexford PA.  To set up a repair service estimate or replacement estimate call Air Systems at (724) 774-9030. So when you ask to find "A good heating and air conditioning repair or service company or plumber near me," you've come to the right place.  Air Systems Mechanical Contracting, Inc. serves Beaver County, Lawrence County, Butler County, Allegheny County.  Air Systems Mechanical Contracting, Inc. services and repairs all makes and models of heating and cooling equipment. Call us for furnace repairs, a/c repairs, free estimates on replacements. Air Systems Mechanical Contracting, Inc. is a Trane Comfort Specialist Dealer. Air Systems Mechanical, Inc services all furnaces, A/Cs, humidifiers, filters, thermostats and water heater brands including Trane, Lennox, Amana, Goodman, Thermopride, Weil McLain, Rheem, April Aire, Honeywell, Carrier.